Prg VL6C+ Manual de usuario descargar pdf (Pagina 54)

46 VL6C+ ™ SPOT LUMINAIRE USER MANUAL

Replacing a Standard Gobo or Color Filter

Parts:

Standard Gobo or Color Filter, as required

Tools:

Screwdriver, #2 Phillips

WARNING: Remove power from luminaire before performing any maintenance procedures.

To remove and replace a standard gobo or color filter:

Step 1. Remove power from luminaire.

Step 2. At head assembly, turn two captive screws one-quarter turn and remove cover (it will remain attached by

tether). (Figure 4-3.)

Step 3. In some cases it is easier to slide the color/gobo bulkhead partially out of the head assembly to access

gobo and color filters. If required, do the following:

a. At Yoke Termination PCB, disconnect cables at locations J10-J17. (Cables are labeled for easy re-

connection.)

b. At color/gobo bulkhead, turn captive screw one-quarter turn to release bulkhead.

c. Remove bulkhead from head assembly.

Figure 4-3: Removing Color/Gobo Bulkhead

Step 4. If not removing color/gobo bulkhead, simply rotate wheel until gobo or color filter is accessible.

Captive Screw

Color/Gobo Bulkhead

Cover

Head Assembly

Removable

Captive Screw (2)

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 69 70

Sin comentarios

Prg VL6C+ Manual de usuario Pagina 54