Prg AutoPar User Manual 2.1 Manual de usuario descargar pdf (Pagina 18)

10 AUTOPAR

WASH LUMINAIRE USER MANUAL

Male Termination Connector

A male XLR termination connector is required at the last luminaire (or "far end of the line")

to prevent signal reflections. Signal reflections may cancel out the signal at certain line

lengths, resulting in errors. The terminator is also necessary for software downloads and

running tests on multiple luminaires. To construct your own connector, you will need the

following components:

+ 5-pin, male XLR connector.

+ Two 1/4W 5% 120 ohm resistors.

Note: A male termination connector is also available as an accessory from PRG. See "Replacement Items and

Accessories" on page 5.

Solder resistors across

pins 2 & 3, and 4 & 5

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Sin comentarios

Prg AutoPar User Manual 2.1 Manual de usuario Pagina 18