Prg AutoPar User Manual 2.1 Manual de usuario descargar pdf (Pagina 22)

14 AUTOPAR

WASH LUMINAIRE USER MANUAL

POWER UP PROCEDURE

Powering Up the Luminaire

When AC power is applied, the luminaire will begin a calibration sequence which moves its pan, tilt, and lens rotation

mechanisms. After calibration, the luminaire head will either stop at its "home" position (which positions the pan axis

at mid-rotation and the head parallel to the yoke with the lens pointing away from the luminaire upper enclosure) or

move to its current DMX-defined position if DMX512 data is present. The lens rotation mechanism will also move to its

"home" or DMX-defined position.

The lamp is set to off in the default mode. DMX512 control is required to strike the lamp.

CAUTION: Before applying power, be sure the luminaire is hung or positioned so that the head and yoke

can move freely without restriction.

CAUTION: If luminaire is operated without yoke leg covers in place, pan problems will occur.

To power up:

Step 1. At each luminaire, connect AC input cable and apply power. Allow luminaire to complete its calibration

sequence.

Step 2. For normal power up, Display Menu will display "Status OK." After a few seconds, Menu will display a DMX

address or "No Comm" if an address has not been set or no DMX512 signal is detected.

Step 3. To strike lamp, send appropriate DMX512 value from console. Refer to "Control Channel Functions" on

page 21.

Figure 2-5: Menu Display at Power Up

Note: Refer to "Menu System" on page 18 for more information about the Menu Display.

ENTER

Status

Menu Display

DMX

No Comm

Luminaire Status

DMX512 Signal

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

Sin comentarios

Prg AutoPar User Manual 2.1 Manual de usuario Pagina 22