Prg AutoPar User Manual 2.1 Manual de usuario descargar pdf (Pagina 36)

28 AUTOPAR

WASH LUMINAIRE USER MANUAL

TROUBLESHOOTING

Error Messages

After calibration, the Menu Display will cycle through any applicable error message(s), one a time until the end of the

list is reached. To review the error messages again, it will be necessary to access them using the Status function.

The following table provides all possible error messages. These errors can be reported for each mechanism (Pan, Tilt,

or Beam), except Enc Fail which does not apply to the Beam mechanism.

To access error messages:

Step 1. Press [Enter] to access top level functions.

Step 2. Press [Up] / [Down] arrows to scroll to Fixture menu. Press [Enter].

Step 3. Press [Up] / [Down] arrows to access Status. (Display will scroll through any error messages or display OK

if no errors.)

CAUTION: If luminaire is operated without yoke leg covers in place, pan problems will occur.

Display Cause

No Sensor

The active sensor state was not detected during calibration. Mechanism

not moving (off sensor), sensor broken or disconnected.

Sensor On

The sensor was stuck active during calibration. Mechanism not moving

(on sensor), sensor broken or disconnected.

Enc Fail

The encoder was not changing during pan or tilt calibration. Mechanism

not moving, encoder broken or disconnected.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

Sin comentarios

Prg AutoPar User Manual 2.1 Manual de usuario Pagina 36