Prg AutoPar User Manual 2.1 Manual de usuario descargar pdf (Pagina 38)

30 AUTOPAR

WASH LUMINAIRE USER MANUAL

ROUTINE MAINTENANCE

Replacing Lamp

Parts:

71.2566.0700.0 LAMP, MSR 700W

Tools:

#2 Phillips Screwdriver

WARNING: Remove power from luminaire before performing any maintenance procedures.

CAUTION: Wear cotton gloves or other covering while installing lamp. Touching lamp glass with bare

fingers will leave oil and may cause the lamp to explode or reduce lamp life. If touched, use alcohol and

cotton cloth to thoroughly clean glass portion of lamp.

To replace lamp:

Step 1. Remove power from luminaire and allow lamp to cool.

Step 2. At backcap, remove four tamper-proof screws and lock washers (Figure 4-1).

Step 3. Pull backcap straight back and out of head assembly.

Step 4. Gripping lamp at base, remove from socket.

Step 5. Install new lamp.

Step 6. Reset lamp hours as required. Refer to "Menu Functions" on page 19.

Step 7. Align lamp according to procedure on next page.

Figure 4-1: Replacing Lamp

CAUTION:

Do not touch lamp or

reflector with bare fingers.

CAUTION:

Allow lamp to cool

before servicing.

Lamp

Backcap

Tamper-Proof

Head Assembly

Screw (4)

Luminaire Yoke Not Shown For Clarity

#6 Int. Tooth

Lock Washer (4)

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 47 48

Sin comentarios

Prg AutoPar User Manual 2.1 Manual de usuario Pagina 38