Prg AutoPar User Manual 2.1 Manual de usuario descargar pdf (Pagina 29)

AUTOPAR

WASH LUMINAIRE USER MANUAL 21

Control Channel Functions

Control channel functions allow special actions such as reset, douse and start. These must be executed with zero

time transition or with console timing disabled. Discrete values must be used; not manual controls such as faders or

encoders (see chart below for values).

Reset - resets all luminaire mechanisms.

Douse - turns lamp off.

Start - strikes lamp.

To use control channel functions:

Step 1. Select an action to be sent.

Step 2. Set control channel value for desired action (for example, 85 for reset). Hold value for 3 seconds.

Step 3. Set control channel value to zero. (This must occur without any scaling values. Action will be voided if other

values are detected between action value and zero.)

Note: A numerical keypad is required for sending values. An encoder or fader does not allow for a quick value

change, which is required to effect the control functions.

DMX Value Action

85 Reset

168 Douse

252 Start

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 47 48

Sin comentarios

Prg AutoPar User Manual 2.1 Manual de usuario Pagina 29