Prg Bad Boy User Manual 1.6 Manual de usuario descargar pdf (Pagina 33)

BAD BOY

SPOT LUMINAIRE USER MANUAL 25

POWER UP AND BASIC SETUP PROCEDURES

Powering Up the Luminaire

When AC power is applied, the luminaire will begin a calibration sequence which moves its pan, tilt, and all beam

control mechanisms. After calibration, the luminaire head will either stop at its "home" position (which positions the

pan axis at mid-rotation and the head parallel to the yoke with the lens pointing away from the luminaire upper

enclosure) or move to its current DMX-defined position if DMX512 data is present. The beam control mechanisms will

also move to their "home" or DMX-defined positions. The lamp is set to OFF in the default mode.

The luminaire also contains an on-board battery so that it can be addressed and configured without being connected

to main power (refer to "On-Board Battery" on page 34).

CAUTION: Before applying power, be sure the luminaire is hung or positioned so that the head and yoke can

move freely without restriction. Refer clearances in Figure 2-5 on page 19.

CAUTION: If luminaire is operated without yoke leg covers in place, pan problems will occur.

To power up:

Step 1. At each luminaire, connect power. Allow luminaire to complete its calibration sequence.

Step 2. For normal power up, the Menu Touchscreen "Home" screen will display Status OK. The Home screen will

also display the luminaire’s DMX address and lamp information.

Step 3. Check Comm LED for proper operation. Refer to "Comm LED Operation" on page 26.

Step 4. To strike lamp, send appropriate command from console or follow steps provided in "Starting the Lamp" on

page 29.

Figure 2-11: Menu Touchscreen at Power Up

Note: Refer to "Menu System" on page 34 for more information about the Menu Touchscreen.

200 - 24 0 VA C

15 A Ma x

50 / 6 0 H z

COMM

DMX

TH R U

ETHERNET

ACIN

Home Screen

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 103 104

Sin comentarios

Prg Bad Boy User Manual 1.6 Manual de usuario Pagina 33