Prg Bad Boy Field Service Manual Manual de usuario descargar pdf (Pagina 63)

BAD BOY

SPOT LUMINAIRE FIELD SERVICE MANUAL 55

Replacing the Frost/Diffuser Paddle

Parts:

22.9812.0557 1 EA ASSY, DIFFUSER PADDLE

Tools:

#2 Philips screwdriver

2mm Allen wrench

Spacer Tool (10.9812.0584)

WARNING: Remove power from luminaire before performing any maintenance procedures.

To replace the Frost/Diffuser Paddle Assembly:

Step 1. Remove power from luminaire and allow components to cool for at least 5 minutes.

Step 2. Remove R2/Designer Wheel Head Cover. (Refer to "Removing the Head Covers" on page 30.)

Figure 3-22: Removing Frost/Diffuser Paddle Assembly

Step 3. Disconnect Frost Sensor Cable.

Step 4. Rotate Frost/Diffuser Paddle Assembly to access set screw. Loosen set screw.

Step 5. Ensure paddle will clear Frost Sensor PCB (rotate if necessary), and remove Frost/Diffuser Paddle

Assembly.

Step 6. Replace Frost/Diffuser Paddle Assembly as follows:

a. Slide new Paddle Assembly onto motor shaft.

b. Insert Spacer Tool between Paddle Assembly and motor, aligning the tool’s notch over the motor shaft.

c. Tighten set screw.

d. Remove Spacer Tool.

Frost/Diffuser

Zoom Assembly

Paddle Assembly

Set Screw

Frost Sensor

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 114 115

Sin comentarios

Prg Bad Boy Field Service Manual Manual de usuario Pagina 63